compression

compression of the earth

地球椭［扁］率

data compression and compaction

数据缩

compression of time and space

时空缩

the chamber of a pump; a compression chamber.

泵房；缩室

This thesis first discussed the essentiality and feasibility of image compression, introduce the method of image compression and the metewand of image compression performance.

本文首先论述了无人机侦察图像数据缩必要性和可行性,并对图像编码主要方法、图像编码性能评价标准进行了详细介绍;

check that the pipe end and compression nut are not bent out of shape.

检查确认管子末端和缩螺帽并未弯曲变形。

unconfined compression test

无侧限缩[力, 抗]试验

It is showed that the flatwise compression of BAHP is same;

结果表明,有无面焊蜂窝铝平性能相差不大;

These factors represent decenter x, decenter y, compression x, compression y, and angle, respectively.

这些分别代表X 偏心,Y 偏心，X 缩，Y缩和角度。

The main factor of spring back density is prepressing pressure, next are compression time and compression number of times.The effect of moisture content was not significant.

回弹后密度影响因子主要为力，其次为加时间和缩次数，而含水率对坯回弹密度影响不明显。

Objective:To find a safe, impactful and economical nonoperative treatment in treatmen of thoracic and lumbar compression fracture.

目:寻找一种安全.有效.经济胸腰椎缩骨折非手术治疗方法。

Stress shielding effect of the trihedral fix trough plate,trapezoid compression plate and Tianjin compression plate on the long bone measured with the electrical measuring method.

用电测法测量了三种股骨中段骨折内固定钢（三面固定槽形、梯形、天津）固定后对骨应力遮挡效应。

In the PC world, archiving and compression usually happen together by using utilities such as PKZIP.

在PC机世界中，归档文件和缩文件通常使用PKZIP应用程序来缩。

Conclusion:The treatment of acupotome can obviously relieve the thebrachial plexus upper trunk of brachiplexnerve compression on scalenus and levator scapula...

结论:小针刀能明显改善臂丛上干神经在斜角肌、提肩胛肌内卡,缓解疼痛。

In fact the level of compression created within a regular pulsejet engine is very low, even by automobile standards.

事实上范围内定期pulsejet引擎创建缩程度很低甚至汽车标准。

Inspection equipment for producing pressure containers, such as tensile ,compression and universal testing machine ,impact machine ,X-ray defectoscope.

抗拉、抗、万能试验机、冲击机、X光拍片射线探伤机等制造力容器检验设备。

A compression moulded part, which has nut inserts and flanges at both ends, is difficult to demould and set in the inserts.

塑件外侧两端各有突缘，且内嵌内螺纹嵌件，造成侧凹脱模和嵌件置入困难。

The current waveform of Ferroelectric ceramics PZT95/5 depoling under tilted shock wave compression has been studied.

摘要研究了冲击波倾斜入射PZT95/5铁电陶瓷时放电特性。

Besides, by using the active biasing circuit (linearizer) for the gate of the FET, the 1dB compression point (CP1dB) can be extended.

除此之外，通过对第二级FET门级偏置使用主动式偏置电路（线性处理器），电路1dB缩点（CP1dB）得到了很大提高。